Working on kit : BB Sangokuden Ryomou Dijeh - mod joints

Yeah since last week been searching, study the mod info on here. So let me show I'll going to do it on my jointless kit, Ryomou Dijeh. ^^"
I've cut the runners into some small size & a D-71 double joint for lower joints.

Cement the small sized runners on either side of the D-71's. I did it so that I can determine the angle when puttying into the leg armor.

Let it dry for 2 ~3 hours 1st.

This is the left armor puttied on with the double joints. Try to center it with just pure guessing...haha...hope it was just right on the center...



For the arm joint, I use D-72 medium size joint for this. The male part to insert the ball joint is drilled a hole, super glue it on the joint.

The finished left leg. Still limited pose but, hey, it's HG-fy now ~

This is the limit the joint can do...haha..^^"

Overall. Left right leg then can see the whole kit. Can't wait ~~



The degree of arm joint can do, great ~



The killer pose that I wanted this kit could do, just 1 more part to do then it's complete ~

Gold pipes ! Like bro NK would do, paint it with gold then panel line it with fabel-castell fine tip pen.

Now puttying the right leg....think tomorrow would be finish ~

=)